1/24/2024 0 Comments Stm32 st link driver windows 10![]() ![]() SWIM flat ribbon with a standard ERNI connector at one end and a 4-pin connector at the other end.Two SWIM cables are delivered with the product: The ST-LINK/V2 should be connected to the STM8 application via the SWIM cable. ST-LINK/V2 USB driver for Windows 7, Vista and XP While connecting the ST-LINK/V2 to the computer through USB interface, the USB driver is required and should be installed correctly first. Microcontrollers supported by STVP release 3.2.8: Product line Status LED which blinks during communication with the PC.Direct firmware update feature supported (DFU).JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector.1.65 V to 3.6 V application voltage supported on the JTAG interface and 5 V tolerant inputs.SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector. ![]() SWIM cable for connection to the application via an ERNI standard vertical (ref: 284697 or 214017) or horizontal (ref: 214012) connector.SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed.SWIM low-speed and high-speed modes supported.1.65 V to 5.5 V application voltage supported on SWIM interface.USB 2.0 full speed compatible interface.STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments. STM8 applications use the USB full speed interface to communicate with STMicroelectronic's ST Visual Develop (STVD) or ST Visual Program (STVP) software. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. ST-LINK/V2, in-circuit debugger/programmer for STM8 and STM32 Speech / Image Recognition / AI Cameras. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |